Mechanical environment influences muscle activity during infant rolling.

An infant's musculoskeletal and motor development is largely affected by their environment. Understanding how different mechanical environments affect an infant's movements and muscle use is necessary to inform the juvenile products industry and reduce incidents involving inclined nursery products each year. The purpose of this study was to determine how the coordinated movements and corresponding muscle activation patterns are affected by different mechanical environments, specifically the back incline angle. Thirty-eight healthy infants (age: 6.5 ± 0.7 months; 23 M/15 F) were enrolled in this IRB-approved in-vivo biomechanics study. Surface electromyography sensors recorded muscle activity of the erector spinae, abdominal muscles, quadriceps, and hamstrings while infants rolled in five different mechanical environments: a flat surface and four device configurations representing a range of inclines infants are commonly exposed to. Coordinated movements were determined using video. In all configurations featuring an inclined seatback angle, infants experienced significantly higher erector spinae muscle activation and significantly lower abdominal muscle activation compared to the flat surface. Infants also exhibited a different coordinated movement featuring spinal extension and a pelvic thrust in the inclined device configurations that was not previously observed on the flat surface alone. Understanding how infants coordinate their movements and use their muscles during rolling in different inclined environments provides more insight into motor development and may inform the juvenile products industry. Many factors impact an infant's movements, therefore future work should explore how other environmental interactions influence an infant's movements and muscle activation, particularly for rolling.

How do babies roll? Identifying the coordinated movements of infant rolling through video compared to laboratory techniques.

BACKGROUND: Rolling is an important developmental milestone for infants where identifying the coordinated movement patterns could facilitate the early identification of motor development delays. Current methods for identifying coordinated movements of rolling are limited to a laboratory setting and not feasible for clinicians. OBJECTIVE: To develop video-based methods in which six coordinated movements, previously defined through motion capture, can be identified through video alone. METHODS: Forty-five videos of sixteen healthy infants achieving a roll were used to develop the video-based methodology and twenty-four videos had corresponding motion capture data used for validation. Four raters comprised of researchers and a clinician identified rolling coordination using the new video-based methods. A Fleiss' Kappa statistical test determined the inter- and intra-rater reliability of agreement for the new methodology and compared it to motion capture. RESULTS: The comparison of the motion capture and video-based methods resulted in substantial agreement. The video-based methods inter- and intra-rater reliability were substantial and almost perfect, respectively. CONCLUSIONS: We developed reliable methodology to accurately identify the coordinated movements of infant rolling using only 2D video. This methodology will allow researchers to reliably define coordinated movements of infants through video alone and may assist clinicians in identifying possible motor development delays and disorders.

Muscle activation and coordinated movements of infant rolling.

Rolling is a critical step of infant development, encouraging muscle coordination and enabling independent exploration. Understanding muscle activity during infant rolling movements on a flat surface is necessary to more fully characterize how the rolling milestone is achieved. The purpose of this study was to determine infants' muscle activation throughout roll initiation for six previously established coordinated movements. Thirty-eight healthy infants (age: 6.5 ± 0.7 months; 23M/15F) were enrolled in this IRB-approved in-vivo biomechanics study. Surface electromyography sensors recorded muscle utilization from the erector spinae, abdominal muscles, quadriceps, and hamstrings while infants rolled. Each rolling movement was categorized as one of six roll types, and the mean muscle activity was analyzed. All roll types required initial activation of all measured muscle groups. Movements featuring axial rotation of the torso relative to the pelvis required highly active erector spinae muscles. Movements featuring trunk and hip flexion required highly active abdominal muscles. Infants used distinct coordinated muscle activations to achieve the six different roll types on a flat surface. A foundational understanding of the different muscle activation patterns required during infant rolling will provide crucial insight into motor development. This study quantified muscle coordination required of infants to achieve rolling on a firm flat surface. Previous research indicates that the mechanical environment in which an infant is placed impacts muscle activity and body position during normal lying. Therefore, future work should explore if mechanical environments that differ from a flat and firm surface also influence these coordinated movements and muscle activations.

Tensile fatigue strength and endurance limit of human meniscus.

The knee menisci are prone to mechanical fatigue injury from the cyclic tensile stresses that are generated during daily joint loading. Here we characterize the tensile fatigue behavior of human medial meniscus and investigate the effect of aging on fatigue strength. Test specimens were excised from the medial meniscus of young (under 40 years) and older (over 65 years) fresh-frozen cadaver knees. Cyclic uniaxial tensile loads were applied parallel to the primary circumferential fibers at 70%, 50%, 40%, or 30% of the predicted ultimate tensile strength (UTS) until failure occurred or one million cycles was reached. Equations for fatigue strength (S-N curve) and the probability of fatigue failure (unreliability curves) were created from the measured number of cycles to failure. The mean number of cycles to failure at 70%, 50%, 40%, and 30% of UTS were estimated to be approximately 500, 40000, 340000, and 3 million cycles, respectively. The endurance limit, defined as the tensile stress that can be safely applied for the average lifetime of use (250 million cycles), was estimated to be 10% of UTS (∼1.0 MPa). When cyclic tensile stresses exceeded 30% of UTS (∼3.0 MPa), the probability of fatigue failure rapidly increased. While older menisci were generally weaker and more susceptible to fatigue failures at high-magnitude tensile stresses, both young and older age groups had similar fatigue resistance at low-magnitude tensile stresses. In addition, we found that fatigue failures occurred after the dynamic modulus decreased during cyclic loading by approximately 20%. This experimental study has quantified fundamental fatigue properties that are essential to properly predict and prevent injury in meniscus and other soft fibrous tissues.

Effect of age on the failure properties of human meniscus: High-speed strain mapping of tissue tears.

The knee meniscus is a soft fibrous tissue with a high incidence of injury in older populations. The objective of this study was to determine the effect of age on the failure behavior of human knee meniscus when applying uniaxial tensile loads parallel or perpendicular to the primary circumferential fiber orientation. Two age groups were tested: under 40 and over 65 years old. We paired high-speed video with digital image correlation to quantify for the first time the planar strains occurring in the tear region at precise time points, including at ultimate tensile stress, when the tissue begins losing load-bearing capacity. On average, older meniscus specimens loaded parallel to the fiber axis had approximately one-third less ultimate tensile strain and absorbed 60% less energy to failure within the tear region than younger specimens (p < 0.05). Older specimens also had significantly reduced strength and material toughness when loaded perpendicular to the fibers (p < 0.05). These age-related changes indicate a loss of collagen fiber extensibility and weakening of the non-fibrous matrix with age. In addition, we found that when loaded perpendicular to the circumferential fibers, tears propagated near the planes of maximum tensile stress and strain. Whereas when loaded parallel to the circumferential fibers, tears propagated oblique to the loading axis, closer to the planes of maximum shear stress and strain. Our experimental results can assist the selection of valid failure criteria for meniscus, and provide insight into the effect of age on the failure mechanisms of soft fibrous tissue.